Tweco 400 XT Ultra-Cut Plasma Cutting System With Automated Gas Control - Manual (Page 37)

ULTRA-CUT 400 XT
Manual 0-5306 INSTALLATION 3-15
Art # A-11998
Fiber Optic
Cable
Plug
Thin nut securing
the through hole
protector
3.13 Set Switches on the Command - Control Module
Remove the power supply upper right side. Set switches on the CCM (Command-Control Module) per the illustrations. Switch
settings and connection details are provided in the Appendix. Any changes made require a restart of the power supply.
CAUTION
Printed circuit boards in the Command - Control Module are static - sensitive. Discharge any built-up
static charges in your body or surroundings before touching the printed circuit boards.