Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 58)

2.4 Formula editor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
42 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
Designation Description Commands
.CP{#}.REF Reference wavelength of the cali-
bration point in nm. CAL Spec
.CYL Cylinder volume of the exchange
or dosing unit used for the com-
mand DET, MET, SET,
KFT, STAT,
STDADD dos,
STDADD auto,
ADD, DOS, LQH,
PREP, EMPTY
.DBL Total duration for the processing
of the command in s DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS, CAL
Cond, CAL MEAS,
CAL Spec,
STDADD, DOS,
ELT MEAS
.DEF Default value which is defined in
the configuration for an IO port ANALOG OUT,
DIGITAL OUT
.DRI Current and/or last drift for drift
correction in µL/min SET, KFT, KFC,
BRC
.DSC Time for processing all start condi-
tions s DET, MET, SET,
KFT, STAT
.DTI Time for drift correction (time
from the start of the titration to
the end of the command) in s SET, KFT, KFC,
BRC
.EGF Last measured gas flow rate
(measured value following pro-
cessing of the command) in
mL/min MEAS T/Flow
.EME End measured value (measured
value after processing of the com-
mand) in the unit of the measured
value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS,
STDADD, DOS,
ELT MEAS