Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 33)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 1 Introduction
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 17
1.11 What is new in tiamo 2.3 Patch 1?
This chapter describes the differences between the new software version
tiamo 2.3 Patch 1 (Build 98-1) and the version tiamo 2.3 (Build 98).
1.11.1 New features
General
New determination examples for conductometric titrations are included in
the delivery.
1.11.2 Improvements
Program part Workplace
￭ For IO and stepper motor controllers, it is possible to access the inputs
from two simultaneously active workplaces, so that determinations can
proceed in parallel.
Program part Configuration
￭ The limitation to two devices applies only for Metrohm devices (Titrino,
Titrando, etc.); that means that balances and other generic (i.e. non-
Metrohm) devices can be included without limitation.
1.11.3 Fixed bugs and problems
General
￭ Beginning with tiamo 2.3 (Build 98), communication between software
and devices has been optimized.
￭ Client ID was output as text at various places (in the header of the
PDF reports and of the report templates, in the program part Data-
base, subwindow Information on the tab Determination, in the
program part Configuration, subwindow Global Variables on the
tab Global Variable), the associated value corresponded however to
the name of the computer. Client ID has now been replaced by Com-
puter name.
Program part Workplace
￭ If a method was programmed in which the check was required at the
time of the Start for one or more method variables of the type Num-
ber (e.g. the Sample size) or Date/Time and which contained a
ERROR track, then the exception wizard would appear in the program
part Workplace at the start of the determination, after the message
014-152 Field empty is exited (tiamo has crashed).