Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1658)

7.21 Stepping motor controller ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1642 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
7.21 Stepping motor controller
7.21.1 Stepping motor controller - Overview
Dialogfenster: Configuration ▶ Devices ▶ [Edit] ▶ Properties… ▶ Properties - 'De-
vice type' - 'Device name'
The properties of a stepping motor controller are set on the following
tabs:
￭ (see Chapter 7.20.2, page 1607)
General device information such as device name, device type, serial
number, etc.
￭ (see Chapter 7.20.3, page 1608)
General settings for the IO controller.
￭ (see Chapter 7.20.4, page 1609)
Digital inputs of the IO controller.
￭ (see Chapter 7.20.5, page 1613)
Digital outputs of the IO controller.
￭ (see Chapter 7.21.6, page 1651)
Stepping motors of the IO controller.
￭ (see Chapter 6.6.3.8, page 1413)
Information on GLP tests and GLP monitoring.
7.21.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
Device name
Name of device (can be freely defined by user).
Input 50 characters
Default value Device type number_#
Device type
Display or selection of the device type.
Wrapper version
Display of the version of AdsWrapper.dll.
Firmware version
Display of the SPS firmware version on the bus controller. Combined of
the bus controller firmware and the version of the bus controller program.
AdsDll version
Display of the version of AdsDll.dll.