Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 115)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Workplace
tiamo 2.3 Patch 1 (for Process Analysis) ￭￭￭￭￭￭￭￭ 99
3.1.4 Workplace - Toolbar
Program part: Workplace
Sample table/New… Open a new and empty sample table (see Chapter 3.3.1.1, page 106).
Sample table/Open… Open a saved sample table (see Chapter 3.3.1.2, page 107).
Sample table/Man-
ager…
Manage saved sample tables (see Chapter 3.3.3.1, page 125).
Change layout Change the layout of the loaded workplace view (see Chapter 3.1.7.2, page
102).
Load view Loads a saved workplace view (see Chapter 3.1.7.3, page 103).
Save view Save the current workplace view (see Chapter 3.1.7.4, page 103).
Run test Carry out the run test for determination(s) (see Chapter 3.6.2, page 131).
Split vertically Split the workplace window vertically and display two workplaces side by side
(see Chapter 3.2.3.3, page 106).
Split horizontally Split the workplace window horizontally and display two workplaces below each
other (see Chapter 3.2.3.4, page 106).
Unsplit Unsplit the workplace window (see Chapter 3.2.3.2, page 106).
Logout Logout user (see Chapter 2.2.3, page 25).
tiamo Help Open tiamo Help.
3.1.5 Workplace - Subwindows
Program part: Workplace
Selection
The following subwindows can be displayed in the main window:
￭ Run
Window for controlling sequences and entering sample data. This sub-
window is permanently on display.
￭ Method
Display of the currently loaded method.
￭ Live display 1
Display of live curves, measured values and messages for the running
determination.