Metrohm tiamo 2.3 Patch 1 (process analysis) - Manual (Page 1266)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1250 ￭￭￭￭￭￭￭￭ tiamo 2.3 Patch 1 (for Process Analysis)
5.6.8.4 REPORT
5.6.8.4.1 REPORT - Overview
Dialog window: Method ▶ REPORT ▶ Properties... ▶ REPORT - 'Command name'
Command for the output of determination data.
Appearance
The command has the following appearance:
Parameters
The parameters for the command REPORT are configured in the follow-
ing dialog window:
￭ REPORT - Properties
Note
A REPORT command must always be placed before a DATABASE
command, because otherwise the command data (e.g., the report tem-
plate used) will not be stored and no reprocessing will be possible .
Command variables
The following command variables are generated in the method run by the
command REPORT and can be used in formulas under the designation
'Command name.Variable designation':
Designa-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command has
never ended