Brandmotion 1008-9527-V2 - Manual (Page 23)

INSTALLATION INSTRUCTIONS
9527 Instructions 6-18-12 F series-1 (1).doc 23 of 38
Section 10: Chassis Harness Installation continued
59. Center punch and drill a pilot hole then
drill a 1 inch hole with a hole saw.
60. Clean the hole with a deburring tool
(Figure 39).
Figure 39
61. Apply supplied Z-tech with a small brush
(Figure 40)
Figure 40
62. Route the supplied chassis harness
through the drilled opening and seat the
grommet from the inside of vehicle (Figure
41).
Figure 41
63. Route the supplied chassis harness
toward the supplied interior harness and
connect together (Figure 42).
Figure 42