Brandmotion 1008-9527-V2 - Manual (Page 14)

INSTALLATION INSTRUCTIONS
9527 Instructions 6-18-12 F series-1 (1).doc 14 of 38
Section 7D: Relocating the Compass Circuit Board
(if required)
Follow the steps in section 7D only if your compass displayed ‘- -‘ when the
mirror connector was removed in Section 5.
40. Solder all connections and cover with
heat shrink tubing or electrical tape.
41. Plug connector into mirror circuit board.
Maintain the original connector orientation:
retaining tab to top side of board (Figure 26).
Figure 26
42. Remove driver’s side knee bolster trim
by removing three screws with a M7 socket.
Pull panel by hand to release mounting clips
(Figure 27).
Figure 27
43. Remove the driver’s side knee bolster
reinforcement by removing the four M8
screws (Figure 28).
Figure 28
44. Route the mirror circuit board connector
as shown. (Figure 29).
Figure 29