Brandmotion 1008-9527-V2 - Manual (Page 15)

INSTALLATION INSTRUCTIONS
9527 Instructions 6-18-12 F series-1 (1).doc 15 of 38
Section 7D: Relocating the Compass Circuit Board continued
(if required)
Follow the steps in section 7D only if your compass displayed ‘- -‘ when the
mirror connector was removed in Section 5.
45. Place the mirror circuit board as shown
(connector facing forward and towards the
bottom). Secure the circuit board to the
existing cross dash harness with the two
supplied long wire ties (Figure 30).
Figure 30