Brandmotion 1008-9527-V2 - Manual (Page 11)

INSTALLATION INSTRUCTIONS
9527 Instructions 6-18-12 F series-1 (1).doc 11 of 38
Section 7A: Removing the Compass Circuit Board
(if required)
Follow the steps in section 7A only if your compass displayed ‘- -‘ when the
mirror connector was removed in Section 5.
32. Pry mirror apart with a screwdriver
(Figure 23).
Figure 23
33. Remove the circuit board from the
mirror by disengaging both connectors. Mark
the top of the circuit board with a permanent
marker to insure proper plug connection later
(Figure 24).
Figure 24
34. Wrap the mirror circuit board in the
supplied foam pieces, and cut an opening for
the connector terminals (Figure 25).
Figure 25
35. Make sure ignition is off. Remove the
original vehicle mirror harness connector by
cutting the harness wires 2 inches from the
connector. Cut wires one at a time and strip
the insulation from each as these will be
spliced to the supplied interior harness.