Brandmotion 1008-9527-V1 - Manual (Page 4)

INSTALLATION INSTRUCTIONS
9527 Ford Flex Instructions 7-27-12.doc 4 of 18
Section 1: Camera Mount Preparation continued
8. Remove any adhesive remaining on the
liftgate.
9. If two camera mounting holes and a camera
harness opening were present in the existing
liftgate, proceed to Section 2. If not, align the
supplied 1008-9100-03 template to the two
existing emblem locating holes and camera
harness opening.
10. Mark and center punch the location for the
two retaining clip holes (Figure 5).
Figure 5
11. Drill the two retaining clip holes with a 3/8
inch drill bit. Use a small flat file to square the
drilled holes for the retaining clips
(recommended method). Alternate method: Drill
the two holes with a 1/8 inch drill bit and use
sheet metal screws (not supplied in kit) to
secure the camera mount.
12. Apply supplied Z-tech to exposed bare metal
with a small brush, and insert supplied retaining
clips (Figure 6).
Figure 6
13. Mark, center punch, and drill a pilot hole for
the camera mount harness opening (Figure 7).
Using a 1¾ inch hole saw, cut the camera
harness opening. Trial fit camera mount and file
opening as necessary.
Figure 7
14. Clean the rough edges of the opening with a
round file or deburring tool.