Brandmotion 1008-9527-V1 - Manual (Page 14)

INSTALLATION INSTRUCTIONS
9527 Ford Flex Instructions 7-27-12.doc 14 of 18
Section 7: Replacing the Sync Microphone
(if required )
Follow the steps on this page only for inside rear view mirrors with built-in Sync
microphone. To retain mic function, Brandmotion Kit #5000-PESMVR must be installed.
60. Splice the supplied microphone harness to the vehicle mirror harness by following the next ten steps and
referring to Diagram E on the next page. Note: Isolate the black, green and pink wires at the black 6 pin
connector end of the supplied interior harness with electrical tape as they will not be used.
• Splice the black ground wire from the supplied interior harness black 16 pin connector end to the wire
in pin 10 of the vehicle mirror harness connector.
• Splice the green reverse wire from the supplied interior harness black 16 pin connector end to the wire
in pin 3 of the vehicle mirror harness connector.
• Splice the pink ignition wire from the supplied interior harness black 16 pin connector end to the wire
in pin 1 of the vehicle mirror harness connector.
• Splice the orange positive (+) auto dimming wire from the supplied interior harness black 16 pin
connector end to the wire in pin 8 of the vehicle mirror harness connector.
• Splice the white negative (-) auto dimming wire from the supplied interior harness black 16 pin
connector end to the wire in pin 7 of the vehicle mirror harness connector.
• Splice the red positive (+) compass wire from the supplied interior harness black 16 pin connector end
to the wire in pin 6 of the vehicle mirror harness connector.
• Splice the yellow negative (-) compass wire from the supplied interior harness black 16 pin connector
end to the wire in pin 2 of the vehicle mirror harness connector.
• Splice the yellow open wire from the microphone harness (supplied separately) to the wire in pin 4 of
the vehicle mirror harness connector.
• Splice the black ground wire from the microphone harness (supplied separately) to the wires in pins 5
and 10 of the vehicle mirror harness connector.
• Splice the blue 12V positive (+) wire from the microphone harness (supplied separately) to the wire in
pin 1 of the vehicle mirror harness.
61. Cover all connections with electrical tape or heat shrink.
62. Place the microphone in a convenient place on A-pillar or in headliner.