Brandmotion 1008-9527-V1 - Manual (Page 13)

INSTALLATION INSTRUCTIONS
9527 Ford Flex Instructions 7-27-12.doc 13 of 18
Section 6D: Relocating the Compass Circuit Board
(if required)
Follow the steps in section 6D only if your compass displayed ‘- -‘ when the
mirror connector was removed in Section 4.
55. Solder all connections and cover with heat
shrink tubing or electrical tape.
Plug connector
into mirror circuit board. Maintain the original
connector orientation: retaining tab to top side
of board (Figure 23).
Figure 23
56. Remove driver side knee bolster trim by
removing three screws with a 7mm socket. Pull
panel by hand to release mounting clips.
57. Place the mirror circuit board connector
under the dash as shown (Figure 24).
Figure 24
58. Make certain the mirror circuit board is
orientated in the same direction it was installed
in the mirror: connector facing forward and
towards the bottom. This verification is required
for the compass to read correctly.
59. Secure the circuit board to the existing cross
dash harness with the two supplied long wire
ties.