Brandmotion 1008-9527-V1 - Manual (Page 17)

INSTALLATION INSTRUCTIONS
9527 Ford Flex Instructions 7-27-12.doc 17 of 18
Section 9: Supplied Mirror Installation
67. Plug the 16-pin connector from the supplied
interior harness into the supplied mirror (Figure
25).
Figure 25
68. Install the supplied mirror on the mounting
button and slide it downwards. Secure by
tightening the T20 Torx screw to 1.8 Nm (16 lb-
in.), while not exceeding 2.2 Nm (19.5 lb-in.).
69. Start vehicle with foot on brake and shift
into reverse to check camera operation. If all of
the connections are correct, you will see an
image displayed on the left side of the supplied
mirror.
70. Use supplied wire ties approximately every
two inches to secure camera harness to existing
vehicle wiring inside the liftgate.
71. Secure any other loose harness wiring using
supplied wire tires.
72. Reinstall all previously removed interior and
exterior parts.
73. Press the supplied emblem into the liftgate
camera mount.