Rockwell Automation MPAS Integrated Linear Stages - Manual (Page 31)

Rockwell Automation Publication MP-UM001D-EN-P - September 2013 31
Mounting and Connecting Chapter 4
For example, if you are mounting an MPAS-B8194F-ALM02C linear stage.
Determine the Type of Fastener to Use
There are three types of fasteners that can be used to mount the linear stage:
• Through bolt
• Toe clip
• Tee nut
Toe clips are supplied with the catalog number MPAS-x6xxx linear stages, and
covered types of the catalog number MPAS-x8xxx and MPAS-x9xxx linear stages.
Refer to the following table for an illustration of each fastener type.
Table 1 - Mounting Fastener Options
fasteners 19 1 + 20 2 × 40 fasteners = = =
1940 mm strokelength 194.0cm =
fasteners
194 cm + 36
12
--------------------------------
230
12
--------- 19.167 = = =
round down 19 =
Fastener Catalog Number Illustration User Supplies
(4)
Recommended For
Through bolt
(1)
— M5 x 1.0 x 16 mm (min) Uncovered stages
Toe clip MPAS-TOE M6 x 1.0 x16mm (min) Covered stages
Tee nut (2) MPAS-x-TNUT (3) M6 x 1.0 Securing a linear stage from beneath the mounting surface
(1) Through bolt mounting is not an option for the catalog number MPAS-x6xxxx-xxxxx (150 mm) linear stages.
(2) The Tee nut mount for a catalog number MPAS-x8xxxx-xxxxx (200 mm) linear stage is a square nut in a T-slot.
(3) Where x is the frame size of a stage, 6 = MPAS-x6xxxx-xxxxx (150 mm), 8 = MPAS-x8xxxx-xxxxx (200 mm), 9 = MPAS-x9xxxx-xxxxx (250 mm).
(4) You supply the bolts.