Rockwell Automation 2706-M1 MESSAGEVIEW 421 HARDWARE MANUAL - Manual (Page 45)

3–22 Front Panel Editor
Publication 2706–816
2. Use the up or down arrow keys to highlight a test.
3. Press the Enter key to run the highlighted test.
Or press the Ack key to return to the Self Tests submenu
without running any (more) tests.
Note: If one of these tests fails, see Page B–2 for a list of the tests
and their explanation.
4. After the test is completed, press the Ack key if necessary to
return to the Self Tests submenu.
5. Press Ack again to return to the Front Panel Editor (FPE)
menu.
To perform the Keypad Test
This tests each key on the terminal’s front panel.
1. Highlight Keypad Test and press the Enter key to initiate
the test.
2. Press and hold each key to test its operation. If the key is
operating correctly, the name of the key is displayed. When the
key is released, the name is replaced by the word Released.
For example, if you press the up arrow key, this message
appears:
Keypad Test
Key =
Up Arrow
If the test fails, see Page B–4.
3. Press the Ack key last, to test the Ack key and to exit the
Keypad Test and return to the Self Tests menu.
4. Press Ack again to return to the FPE menu.