Rockwell Automation 6186M-xxxx Industrial Performance Monitors User Manual - Manual (Page 51)

Rockwell Automation Publication 6186M-UM002B-EN-P - March 2012 51
Chapter
4
Perform Routine Maintenance
Chapter Objective This chapter describes how to clean the monitors and perform other routine
maintenance.
Cleaning the Monitor Occasionally clean the display panel and cabinet with a soft cloth dampened (not
soaked) with a mild (nonabrasive) glass cleaner. Keep turning a fresh side of the
cloth toward the screen surface to avoid scratching it with accumulated grit.
Be careful when cleaning a touch screen shield that is installed over the screen.
Abrasive and certain chemical cleaners can easily damage the surface.
Replacing a Line Cord To avoid shock and fire hazards, replace the monitor’s power cord if the
insulation breaks or if the cord develops a loose internal connection. Contact
your authorized Allen-Bradley distributor for ordering information.
Other Maintenance Qualified service personnel should perform all maintenance, except for the
power cord replacement. Contact Allen-Bradley Technical Support for
assistance.
IMPORTANT Apply the solvent only to the cloth, and not directly on the monitor screen.
Do not use paper products as they may scratch the surface. To minimize the
risk of abrasion, allow the screen to stand dry.
ATTENTION: You can use alcoholic or ammonia cleaners to clean the
polycarbonate shield or a touch screen. However, use only one or the
other at all times. A residue mixture can cause a chemical reaction.
Cat. No. Description
6189V-SCRNCOVER12 12" Screen Cover for flat front bezels
6189V-SCRNCOVER15 15" Screen Cover for flat front bezels
6189V-SCRNCOVER17 17" Screen Cover for flat front bezels
6189V-19SCRNCVR 19" Screen Cover for flat front bezels