Rockwell Automation 6186M-xxxx Industrial Performance Monitors User Manual Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for 6186M-xxxx Industrial Performance Monitors User Manual Rockwell Automation
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 64 |
| Size: | 6.65 MB |
Show table of contents
Document Outline
- Front Cover
- Important User Information
- Summary of Changes
- Table of Contents
- Preface
- Chapter 1: Monitor Overview
- Chapter 2: Installing the Monitor
- Chapter Objectives
- Hazardous Locations
- European Union Directive Compliance
- Backlight Assembly Disposal
- Environment and Enclosure Information
- Installation Guidelines
- Product Dimensions
- Panel Mounting
- Rack Mounting
- Bench or Tabletop Mounting
- Mount the DIN Rail of the AC Power Adapter
- 1. Attach the DIN rail bracket to the bottom of the AC power adapter (1).
- 2. Secure the DIN rail bracket by using four of the provided M4 x 6 mm screws (2).
- 3. Torque the screws to 0.882 N·m (7.811 lb·in).
- 4. Attach the DIN rail to the wall or installation surface (3) by using two M4 x 6 mm screws (4); if using an existing DIN rail skip to the next step.
- 5. Torque the screws to 0.882 N·m (7.811 lb·in).
- 6. Mount the AC adapter on the DIN rail by inserting the upper lip of the DIN rail bracket on the top edge of the DIN rail (5), then pressing the AC adapter firmly against the lower edge of the rail (6).
- 7. Secure the installation by tightening the fastener on the DIN-rail bracket (7).
- Monitor Connections
- Video Source Connection
- Table 9 - Digital Video Accessories
- Connect to a Host Digital Video Source
- Connect to a Host Analog Video Source
- Connect the Optional Touch Screen Interface
- Connect the Optional Serial RS-232 Touch Screen Interface
- Connect the USB and Optional USB Touch Screen Interface
- Install the Touch Screen Driver Software
- 1. RS-232 Interface: Verify that the supplied RS-232 cable is properly installed between the RS-232 input connector on the monitor and the host’s COM port.
- 2. USB interface: Verify that the USB cable is properly installed between the USB input connector on the monitor and a USB port on the host computer.
- 3. Install the touch screen driver found on the Accessories CD or at http://www.rockwellautomation.com/compatibility/#/downloads.
- Perform a Calibration
- Power Source Connection
- Connect AC Power
- Table 13 - AC Power Adapter Accessories
- 1. Turn off the main power switch or breaker.
- 2. Connect the AC adapter’s 12V AC input cable to the 12V DC power- input connector on the monitor (1) and secure this connection by screwing the barrel over the threads (2).
- 3. Hard wire the AC power by using the provided AC power cord (3).
- 4. Restore AC power.
- Connect DC Power
- 1. Turn off the main power switch or breaker.
- 2. Route the power wires from your DC power supply and connect the leads to the DC input terminal block on the monitor.
- 3. Tighten the screw terminals to provide a good connection.
- 4. Secure the terminal block connector to the unit by using the two side screws.
- 5. Restore DC power.
- Secure the Cables
- Functional Ground Screw
- Connect AC Power
- Chapter 3: Display Configuration
- Chapter 4: Perform Routine Maintenance
- Chapter 5:Troubleshoot the System
- Appendix A: Specifications
- Appendix B: Video Cables
- Index
- Back Cover/Rockwell Support