beautypg.com

Table 12 - usb type a connection accessories, Install the touch screen driver software, Perform a calibration – Rockwell Automation 6186M-xxxx Industrial Performance Monitors User Manual User Manual

Page 36

background image

36

Rockwell Automation Publication 6186M-UM002B-EN-P - March 2012

Chapter 2

Installing the Monitor

Connect the USB and Optional USB Touch Screen Interface

The USB type A connection to the host computer is used to allow USB devices
and optional USB touch screen interface to the host computer.

Follow these directions to connect the touch screen interface.

1. Connect the USB Type B male connector end of the included USB cable

to the USB Type B female connector on the monitor.

2. Connect the USB Type A male connector on the USB cable to the USB A

Type female connector on the host computer.

Install the Touch Screen Driver Software

Before installing the touch screen driver software, check the following for the
interface you are using.

1. RS-232 Interface: Verify that the supplied RS-232 cable is properly

installed between the RS-232 input connector on the monitor and the
host’s COM port.

2. USB interface: Verify that the USB cable is properly installed between the

USB input connector on the monitor and a USB port on the host
computer.

3. Install the touch screen driver found on the Accessories CD or at

http://www.rockwellautomation.com/compatibility/#/downloads

.

Perform a Calibration

After installing the driver software, follow the calibration instructions in the
touch screen documentation. Once the touch screen software and calibration is
installed, the touch screen is ready to use.

Table 12 - USB Type A Connection Accessories

Cat. No.

Description

6189V-TCHCBL2

Serial touch cable, RS-232 cable, 1.8 m (6 ft)

6189V-USBCBL2

USB/USB touch cable, Type A to Type B, 1.8 m (6 ft)

6189V-USBKEY

USB key