Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 99)

1 Publication 2707-PM002B-EN-P
Chapter
14
Transferring / Printing Application Files
Chapter Objectives This chapter describes how to transfer application files between a
MicroView and a personal computer. Also provided is a description
of how to print out an application file.
Program Mode Setting Before you can upload or download an application, you must set the
MicroView to the Program Mode. Refer to the MicroView User Manual
for information on how to access the Program Mode.
Communication Cables You will need a programming cable, Catalog No. 2707-NC8. If you
need to construct your own cable. refer to the cable diagrams
provided in the MicroView User Manual.
Power Supply You will also need a MicroView Power Supply (Catalog No.
2707-PS120 or 2707-PS220) to power the MicroView during the
program transfer.
Computer Setup Upload and download functions are initiated from a personal
computer running the programming software DPS. All transfer
functions occur at 9600 baud.
After the transfer is complete, the MicroView baud rate is set to the
parameters defined by the application program residing in the
MicroView.
Section Page
Program Mode Setting 14-1
Communication Cables 14-1
Power Supply 14-1
Computer Setup 14-1
Downloading an Application 14-2
Uploading an Application 14-5
Printing Application Files 14-8