Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 79)

1 Publication 2707-PM002B-EN-P
Chapter
12
Entering MicroView Configuration Data
Chapter Objectives This chapter describes how to set the configuration parameters of the
MicroView.
Configuration Parameters The following configuration parameters can be set. These parameters
are downloaded with the application and override any settings that
are currently used by the MicroView.
Section Page
Configuration Parameters 12-1
Accessing Configuration Data 12-2
Update Interval 12-3
MicroView Advisor 12-4
Advisor Operation 12-5
Setting Master Security Code 12-6
Special Security Screen 12-7
MicroLogix Hardware Parameters 12-9
Parameter Description
Update Interval Defines the rate at which the screen display is updated.
MicroView Advisor Assign advisor register data allowing screen changes by a
controller.
Set Master Security Code Sets the master security code allowing an operator access
to security screens and codes.
Special Security Screen Restricts access to the Mode Menu of the MicroView to
prevent unauthorized access to controller functions.
PLC Hardware Parameters Defines the communication parameters between a
controller and the MicroView.