Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL User Manual

Page 15

Publication 2707-PM002B-EN-P

Installing and Running the MicroView Programming Software 2-5

7. Press [Return] to install the DPS software in the \MDPS

subdirectory. The Install program creates the subdirectory. If
you enter your own subdirectory name, the entire path name
including colons, forward slash, and name should not exceed 28
characters.

The status of the installation is displayed on the screen.

The DPS Configuration Utility screen then appears:

8. Enter your name, company name, and software serial number

(on registration card). Also, enter the monitor type and
communication port used by your computer.

The software serial number is required when requesting phone
support (refer to startup screen on next page).

9. After responding to the above questions, you are asked to

confirm the configuration. Press [Return] to accept the
configuration.

10. The installation is complete. You are returned to DOS at the

new subdirectory C: \MDPS>.

TIP

Press [Return] at the Video Type and Comm
Port questions to prompt the user for this
information during application development.