Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 91)

1 Publication 2707-PM002B-EN-P
Chapter
13
MicroView Function Key Builder
Chapter Objectives This chapter describes how to use the Function Key Builder to assign
screen selection or bit write operations to function keys. The chapter
contains these sections:
Function Key Options You can link the MicroView function keys, F1 and F2, to the following
screens depending upon whether or not Auto Return is enabled.
Pressing an assigned function key displays the function key number
for approximately 0.5 seconds and then the assigned screen. There
are two function key modes:
•
Auto Return
•
Continue
Section Page
Function Key Options 13-1
Bit Write Mode 13-3
Function Key Builder 13-4
Linking Screens to Function Keys 13-5
Assigning Bit Write Functions 13-6
Auto Return Enabled? Function keys can be assigned to these screens:
Yes Data Display, Data Entry, Recipe
No Menu, Sub-Menu, Data Display, Data Entry, Security,
Recipe