Rockwell Automation 2707-NP2 MICROVIEW SOFTWARE PROGRAMMING MANUAL - Manual (Page 8)

Publication 2707-PM002B-EN-P
1-2 Using this Manual
Intended Audience The MicroView Programming Software does not require special
programming knowledge. It is menu driven and generates an
application program based on your menu selections and data entries.
If you are creating an application for a MicroView, you should be
familiar with the user manuals. Refer to related publications in this
chapter.
11 Linking Menu and Application
Screens Describes how to link all of the
application screens into a logical
sequence.
12 Entering Configuration Data Describes how to enter configuration
data that allows the MicroView to
communicate with a controller.
13 MicroView Function Key Builder Describes how to assign screen
navigation or bit write functions to the
MicroView function keys.
14 Transferring / Printing
Application Files Describes how to transfer applications
between a personal computer and the
MicroView.
15 Upgrading the Operating System Describes how to install a new system
software.
Appendix A ASCII Display Characters The character set supported by the
MicroView.
Appendix B Application and Screen
Worksheets Worksheets assist in the design of an
application and individual screens.
Appendix C Mnemonics in DPS Reference section for MicroLogix
mnemonic codes used for addressing.
Appendix D Data Formats Description of the data formats used by
MicroLogix controllers.
Chapter Title Purpose
IMPORTANT
The MicroView Operator Interface is for use with the
MicroLogix Controllers only.