Rockwell Automation 2080 Micro800 Digital and Analog Plug-in Modules User Manual
Micro800 plug-in modules
Table of contents
Document Outline
- 2080-UM004B-EN-E Micro800 Plug-in Modules User Manual
- Preface
- 1 - Micro800 Plug-in Modules
- 2 - Install and Wire Your Module
- Install and Wire Your Module
- Hardware Features
- Insert Module into Controller
- 1. Position the plug-in module with the terminal block facing the front of the controller as shown.
- 2. Snap the module into the module bay.
- 3. Using a screwdriver, tighten the 10…12 mm (0.39…0.47 in.) M3 self tapping screw to torque specifications. See Specifications on page 57 for torque specifications.
- Wiring
- Wiring Considerations and Applications for 2080-TC2
- Wiring Considerations and Applications for 2080-RTD2
- Wiring Applications for 2080-MOT-HSC
- Notes:
- Install and Wire Your Module
- 3 - Non-isolated Thermocouple and RTD Plug-in Modules – 2080-TC2 and 2080-RTD2
- 4 - High Speed Counter – 2080-MOT-HSC
- 5 - DeviceNet Plug-in – 2080-DNET20
- A - Specifications
- B - Quickstart
- Quickstart
- Add and Configure Plug-ins in Connected Components Workbench
- Quickstart Project for 2080-DNET20 Plug-in
- Setup and Wiring
- 1. Insert your 2080-DNET20 module into the designated plug-in slot in your Micro800 controller.
- 2. Next, wire your 2080-DNET20 plug-in following the diagram shown below.
- 3. Configure the DeviceNet devices as shown below.
- 4. Set the node address for the CompactBlock LDX through the node switches to node 1.
- 5. Set the node address for the PowerFlex drive through the 25-COMM-D to node 2. Set the baud rate to autobaud.
- Configuration
- 1. Launch Connected Components Workbench and open the sample project you have downloaded from the Sample Code Library.
- 2. Import the following DNET UDFBs into your project:
- 3. Configure the RA_DNET_MASTER UDFB as shown.
- 4. Configure the PowerFlex UDFB as shown (that is, set the node address, plug-in slot ID, and so on).
- 5. Configure the CompactBlock LDX UDFB as shown (that is, set the node address, plug-in slot ID, Module1…Module4).
- Build and Download
- Execute Program
- Setup and Wiring
- Quickstart Projects for 2080-MOT-HSC Plug-in
- Quickstart
- C - Error Codes
- Index
- Back Cover