Rockwell Automation 2080 Micro800 Digital and Analog Plug-in Modules - Manual (Page 92)

84 Rockwell Automation Publication 2080-UM004B-EN-E - December 2013
Appendix B Quickstart
Quickstart Projects for
2080-MOT-HSC Plug-in The following quickstart projects will show you how to write and use three user-
defined function blocks to configure and use your Micro800 High Speed
Counter plug-in.
Setup and Wiring
1. Insert the high speed counter plug-in module into the designated slot in
your Micro800 controller.
2. Wire your plug-in to your controller as shown in the following diagram.
IMPORTANT Quickstart Prerequisite
For the following quickstart projects, you first need to download the HSC
UDFBs and sample project from the Sample Code Library:
http://www.rockwellautomation.com/go/scmicro800
1 2 3 4
1 2 3 4
Back
Front
(View into terminal block)
Pin A1 0-
Pin B1 0+
Pin A2 A- Pin B2 A+
Pin A3 B- Pin B3 B+
Pin A4 Z- Pin B4 Z+
B
A
0-
A-
B-
Z-
A+
B+
Z+
0+ DC(+)
DC(-)
CR
CR
0-
A-
B-
Z-
A+
B+
Z+
0+ DC(+)
DC(-)
Sinking Output Wiring Sourcing Output Wiring
NOTE: Output functionality is
not currently supported and is
dependent on availability of
UDFB support.