Rockwell Automation 6181P-xxxx Integrated Display Computers, Series A to D - Manual (Page 64)

64 Publication 6181P-UM001G-EN-P - July 2008
Appendix D Solid State Drive
•
The solid state drive installs on the computer’s IDE bus via the
IDE ribbon cable. Pay close attention to connector alignment.
Careless assembly can bend a pin or misalign the connectors,
resulting in hardware damage.
Configuration The solid state drive is configured for a single drive system, or as a
master in a multiple drive system. The diagram indicates the various
operating configurations.
IDE Drive Connector Interface
The solid state drive uses a 44-pin (2 mm pitch) connector to attach to
the IDE bus.
IMPORTANT
You must power off the drive whenever making a mode change.
Pin 1 Pin 2 Pin 43
Pin 44
A
C A
D B
C A
D B
C A
D B
Master (Factory Default) Slave Cable Select
Mode
Settings