Rockwell Automation 6181P-xxxx Integrated Display Computers, Series A to D - Manual (Page 43)

Publication 6181P-UM001G-EN-P - July 2008 43
Replace System Components Chapter 4
Remove the Drive
Follow these steps to remove the drive.
1. Disconnect power from the computer.
2. Carefully separate the display head from the back chassis by
removing the 12 perimeter screws.
3. Disconnect cables between the display and back chassis as
necessary and set the back chassis aside.
4. Remove the floppy or optical disc drive bay by removing the
four screws holding the bracket to the inner shelf.
5. Carefully pull out the drive bay assembly.
6. Disconnect the data, power and audio cables from the assembly.
7. For either floppy or optical disc drive removal; disconnect and
remove the drive adapter board from the drive.
Be careful with the delicate ribbon cable on the floppy disk
drive.
IMPORTANT
Note the location and orientation of all cables before you
remove the existing power supply and cabling, so that you can
reattach them correctly.