Rockwell Automation 6181P-xxxx Integrated Display Computers, Series A to D - Manual (Page 45)

Publication 6181P-UM001G-EN-P - July 2008 45
Replace System Components Chapter 4
Replace the Optical Disc
Drive (1500P and 1700P) Follow these precautions when working with the floppy or optical
disk drive.
•
Do not touch internal components unnecessarily.
•
Always handle the drive by its metal frame.
•
Store the drive in an anti-static bag when it is not installed.
•
Never disconnect or install a drive with the power on.
Remove the Drive
Follow these steps to remove the drive.
1. Disconnect power from the computer.
2. Remove the back cover.
3. Disconnect the power supply, audio cable, and ribbon cable
from the adapter printed circuit board.
4. Remove the two screws that fasten the drive assembly to the
chassis.
5. Lift the drive assembly out of the chassis.
6. Remove the four screws that fasten the drive brackets to the
drive and remove the brackets from the drive.
ATTENTION
Failure to follow proper safety precautions could result in
severe electrical shock and/or damage to the computer.
ATTENTION
Mechanical shock can damage an optical disc drive. Do not
drop or bump the drive.
IMPORTANT
Note the location and orientation of all cables before you
remove the existing power supply and cabling, so that you can
reattach them correctly.