Rockwell Automation 6181P-xxxx Integrated Display Computers, Series A to D - Manual (Page 39)

Publication 6181P-UM001G-EN-P - July 2008 39
Replace System Components Chapter 4
Remove an Add-in Card
Follow these steps to remove an add-in card.
1. Disconnect power from the computer.
2. Remove the back cover.
3. Remove the two screws securing the slot cover bracket to the
chassis.
4. Remove the two screws at the top of the PCI riser board.
5. As a single unit, remove the PCI riser board, add-in card, and
slot cover bracket from the PCI slot on the CPU board.
6. Remove the screw securing the slot cover bracket to the add-in
card.
7. Pull the add-in card free of the slot on the PCI riser board.
Store the card in an anti-static wrapper.
8. Install a slot cover over the open slot on the slot cover bracket
and secure with a screw from step 6.
9. Press the PCI riser board into the PCI slot on the CPU board.
10. Replace the two screws at the top of the PCI riser board from
step 4.
11. Secure the slot cover bracket to the chassis with two screws
from step 3.
12. Reinstall the back cover.