Rockwell Automation 6181P-xxxx Integrated Display Computers, Series A to D - Manual (Page 19)

Publication 6181P-UM001G-EN-P - July 2008 19
Installation Chapter 2
Panel Mounting Install the computers by using mounting clips. Before installation,
review:
•
Tools required.
•
Panel mounting guidelines.
•
Panel cutout dimensions.
•
Product dimensions.
Tools Required
The following tools are required for product installation:
•
Panel cutout tools
•
#2 Phillips screwdriver
Mounting Guidelines
Observe these guidelines when installing the unit in a panel.
•
Confirm that there is adequate space behind the panel. A
cabinet with a minimum depth of 127 mm (5.0 in.) is sufficient.
•
Cut supporting panels to specifications before installation. Take
precautions so metal cuttings do not enter components already
installed in panel.
•
Supporting panels must be at least 14 gauge to ensure proper
sealing against water and dust and to provide proper support.
The mounting hardware supplied accommodates panels up to
6.25 mm (0.25 in.) thick.
Panel Cutout Dimensions
ATTENTION
Failure to follow these guidelines may result in personal injury
or damage to the panel components.
Computer Model Cutout Dimensions (HxW)
1200P 254.0 x 324.0 mm (10.0 x 12.76 in.)
1500P 285.0 x 386.6 mm (11.24 x 15.22 in.)
1700P 329.5 x 424.0 mm (12.97 x 16.69 in.)