Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual User Manual
Page 45
Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014
45
Component Replacement
Chapter 4
4. If necessary, remove any accessory
boards or cables that prevent access to
the RTC battery socket.
5. Remove the old battery.
a. Pull the battery cover straight out
of the battery socket.
b. Pull the old battery from its socket.
6. Install the new battery.
a. Insert the new battery with the
positive polarity (+ side) towards
the SO-DIMM memory slots.
Verify that the battery is seated
completely.
b. Reinstall the battery cover.
7. Follow the steps for
.
8. During POST, press F2 on an attached keyboard to access the UEFI setup
and reconfigure settings.
for more information on UEFI settings.
TIP
The socket retaining latches allow only one way for the battery to be
installed.
IMPORTANT
If you replace the battery, then all UEFI settings return to their default
settings. UEFI settings other than default must be reconfigured after
you replace a battery.
This computer contains a sealed lithium battery that could need
replacement during the life of the computer.
At the end of its life, collect the battery that is contained in this computer
separately from any unsorted municipal waste.
Remove old battery.
Install new battery.
Battery Cover
RTC Battery
Battery Socket
Socket
Retaining
Latches