Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual - Manual (Page 101)

Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014 101
Accessories Installation Appendix B
5. Remove the screw that secures the slot cover of the selected PCI slot (A).
6. Pull out the slot cover (B) and store it.
7. Remove the add-in card from its protective packaging.
8. Slide the add-in card into the selected PCI slot (C).
Press to verify that it is firmly seated.
9. Secure the add-in card bracket to the chassis with its screw (D).
10. Connect any necessary cables to the card.
11. Reinstall the chassis cross member or I/O card retention bracket as
detailed in Install I/O Card Retention Bracket on page 98 .
12. See any installation instructions that came with the add-in card to verify
that all installation steps are followed.
13. Follow the steps for Post-configuration on page 37 .
IMPORTANT Do not discard the slot cover. If the add-in card is removed in the
future, the slot cover must be reinstalled to maintain proper cooling.
IMPORTANT The chassis cross member or I/O card retention bracket must be
installed for vibration and shock purposes.
Install an add-in card on the 750R computer.
Install an add-in card on the 1450R computer.
A
A
C
C
B
B
D
D