Start the computer – Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual User Manual
Page 32
32
Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014
Chapter 3
Operation
Start the Computer
Follow these steps to start the computer.
1. Make sure any connected components with separate power supplies (such
as an external display) are turned on first.
2. Make sure all necessary peripheral devices are connected to the corresponding
I/O ports on the computer.
3. If you have a1450R computer and the front
door is locked, complete the following steps:
a. Unlock the front door with the provided
key.
b. Open the door to access the power
switch.
4. Plug the AC power cable into the power
input on the computer and into a power
source or wall outlet.
5. Press the power switch.
for the power switch location.
The computer performs certain actions when it is started or reset. See
.
If your computer does not start or you notice other anomalies, refer to the
IMPORTANT
The following steps apply to when you must manually start the computer. See
for when power is applied to the computer for the
first time.
SHOCK HAZARD: Connect the AC power cord to a power source with an
earth ground. Failure to follow this warning can result in electrical shock.