Rockwell Automation 6189V-xxxx Non-display Industrial Computers User Manual - Manual (Page 102)

102 Rockwell Automation Publication 6177R-UM002D-EN-P - October 2014
Appendix B Accessories Installation
Install Rack Slides
(1450R Computer) You can install the 1450R computer in a rack cabinet. The computer must be
supported by rack slides or fastened to a shelf.
Follow these steps to install the rack slides and mount the 1450R computer in a
rack cabinet.
1. Remove the inner rails from each rack slides.
a. Extend the inner rail from the rack slide until the rail-release latch clicks
(A).
b. Depress the inner rail-release latch and slide the inner rail out (B).
2. Attach each rack slide to the computer by using five screws in the holes
marked ‘2.’
Torque the screws to 1.3 N•m (12.1 lb•in).
3. Attach the left and right mounting rails at the desired U position in the
rack cabinet by using four screws (C), two adapter plates (D), and four
nuts (E) for each mounting rail (F).
4. Extend the middle sliding piece of each mounting rail forward until you
hear an audible click (G).
A
B