Rockwell Automation 1790P-T4T0 CompactBlock LDX I/O Thermocouple Modules - Manual (Page 104)

Publication 1790-UM003A-EN-P - May 2002
I-2
D
data configuration for DeviceNet
3-1
data format
3-3
data word
definition
G-1
dB
definition
G-1
decibel. See dB.
definition of terms
G-1
determining module update time
3-12
DeviceNet cable
connecting
2-9
DeviceNet specifications
A-2
DeviceNet Thermocouple/mV module
3-14
configure using RSNetWorx
3-15
diagnostic features
general
1-4
diagnostics and troubleshooting
4-1
channel diagnostics
4-4
module operation vs channel operation
4-2
power-up diagnostics
4-3
safety considerations
4-1
diagnostics and troubleshootings
channel LED indicator operation
4-5
differential mode rejection. See normal
mode rejection.
digital filter
definition
G-1
DIN rail mounting
2-8
E
effective resolution
3-7
definition
G-2
electrical noise
2-5
environmental specifications
A-1
F
fault condition
at power-up
1-4
field wiring connections
2-12
filter
definition
G-2
filter frequency
3-4, 3-5, 3-7
and channel cutoff frequency
3-5
and channel step response
3-5
and noise rejection
3-4
definition
G-2
frequency response graphs
3-6
frequency. See filter frequency.
full-scale
definition
G-2
full-scale range
definition
G-2
G
general diagnostic features
1-4
general specifications
A-3
grounding
2-13
H
hardware features
1-3
general diagnostic features
1-4
hazardous location considerations
2-2
heat considerations
2-5
I
important user information
iii
indicator lights
4-1
input data file
3-2
input data values
3-2
over-range flag bits
3-3
under-range flag bits
3-2
input data scaling
definition
G-2
input data values
3-2
input image
definition
G-2
input image file data
accessing
3-1
installation
2-13
getting started
2-1
grounding
2-13
heat and noise considerations
2-5
installation and wiring
2-1
before you begin
2-1
field wiring connections
2-12
system wiring guidelines
2-12
wiring terminal blocks
2-15
wiring the modules
2-14
general considerations
2-2
hazardous location considerations
2-2
installing CompactBlock LDX I/O
2-6
protecting circuit board
2-6
selecting a location
2-5
set node address (DeviceNet)
2-6