Rockwell Automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE Input and Scheduled Output Modules UM - Manual (Page 50)

40 Rockwell Automation Publication 1732E-UM003B-EN-E - March 2014
Chapter 6 Configure the Module Using RSLogix 5000 Software
3. The New Module dialog appears.
Fill in the Module Properties information as shown, and then click OK.
You can either accept or change the default configuration as shown.
Module Properties Values
Field Name Value
Name TEST_1732EIB8M8SOER or TEST_1732EOB8M8SR
IP address 192.168.1.20
Electronic keying Compatible Module
Connection Format Data (This field does not exist for the 1732-EOB8M8SR module.)
Revision 1.1
Timestamp Per Point
A. Name the module.
B. Enter theIP address of the module as
shown.
C. Make sure the Module Definition
information matches this example.
D. Click Change... to edit the Module
Definition for your module before
downloading the program to the controller.
E. Click OK to accept the default
configuration.
On the General tab, the 1732E-OB8M8SR module
does not have a Connection Format field under
Module Definition section.
1732E-IB8M8SOER
1732E-OB8M8SR