Rockwell Automation 1732E-OB8M8SR EtherNet/IP Dual Port 8-Point SOE Input and Scheduled Output Modules UM - Manual (Page 44)

34 Rockwell Automation Publication 1732E-UM003B-EN-E - March 2014
Chapter 6 Configure the Module Using RSLogix 5000 Software
Set Up the Hardware In this example, a ControlLogix chassis contains the Logix5565 processor in slot
1 and a 1756-EN2T bridge module in slot 3. The 1732E ArmorBlock module is
mounted remotely.
To work along with this example set up your system as shown.
• Note that in the example application, the Logix5565 controller and
1756-EN2T module (firmware version 2.3 or higher) are assumed to be in
the slots shown.
• Verify the IP addresses for your programming terminal, 1756-EN2T
module and 1732E ArmorBlock Ethernet module.
• Verify that you connected all wiring and cabling properly.
• Be sure you configured your communication driver (for example,
AB_ETH-1 or AB-ETHIP-1) in RSLinx software.
Logix5565
1756-EN2T
EtherNet/IP
Logix5565
LINK2 LINK1
NET MOD X10
X100 X1
AUX POWER
Local
Chassis 1732E
ArmorBlock
Logix5565
Controller (slot 1)
1756-EN2T
192.168.1.1 (slot 3)
Data
Switch
192.168.1.100
Programming
Terminal
0
1732E ArmorBlock
Ethernet Module
192.168.1.20
44971
3 2 Slot 1
Embedded
Technology