beautypg.com

Rockwell Automation 1760 Pico GFX-70 Controllers Quick Start User Manual

Page 53

background image

Publication 1760-QS002A-EN-P - April 2004

Lesson 5 7-11

We must also connect the PC to the master that is always represented by the
device shown on the far left (see following figure). For this we require the
1760-CBL-PC02 PC connection cable.

Three stations connected via Pico-Link.

The figure above shows the Pico-Link configuration consisting of three
stations (1), two Pico-Link connection cables 1760-CBL-INT01 (2) and two
bus terminating resistors 1760-TERM1 (3).

Before changing to Communication View, check whether the correct COM
interface is set on your PC. Choose Communication, Interface to determine
which interface is selected and, if necessary, select another one.

We are now read. We then select Communication View using the appropriate
button in the Toolbox.

If the change to Communication View is excessively long and an error message
is output, check/change the selected interface.

Choose Communication, Online to restart the connection establishment.

Once the Communication View has been called up, we must then configure
the Pico-Link.