Rockwell Automation 1760 Pico GFX-70 Controllers Quick Start - Manual (Page 49)

Publication 1760-QS002A-EN-P - April 2004
Lesson 5 7-7
Program for Device 2 (Pico-Link ID 2)
The Properties fields for the two bit outputs must be set as follows:
Enter the number of the operand in the SN list box, 1 for SN1 and 2 for SN2.
The preceding station number (Pico-Link ID) must be set to 1 for both SN
operands since the signals are to be sent to the Pico-Link station 1 (master).
To read the P buttons, we must enable them beforehand.
1. To do this we return to Project View and left-click Device 2. The
parameter dialog will appear in the Properties field.
2. Select the System tab and activate the P Buttons check box (see the
following figure).
Bit output SN 1 Bit output SN 2