Rockwell Automation 1329I DeviceNet Option FRN 1.XXX - Manual (Page 29)

Configuring the 1329I Unit and DeviceNet Option 3-11
Figure 3.16 Modifying the Change of State Mask
2. Select the bits (an “X” appears) that you want reviewed for changes, and
then click Save to Device.
3. Click OK to close the dialog box.
Resetting the DeviceNet
Option For changes to some parameters in the option to take effect, you must reset
the option. Parameter 113 - [Reset] can be used to reset the option, restore
the option parameters to their factory default settings, or restore the drive
parameters to their factory default settings. To reset the option:
1. In the Device Configuration - Enhanced Mode dialog box ( Figure 3.8 ),
double-click Parameter 113 - [Reset]. The Device Configuration -
Modify Enumerated Parameter dialog box appears.
Figure 3.17 Modifying the Reset Parameter
!
ATTENTION: Hazard of equipment damage, injury, or death
exists. Resetting the option may fault the 1329I unit, resulting in
equipment damage, injury, or death. Ensure that the 1329I unit
can stop safely before resetting it.