Rockwell Automation 1413-ME-PEA Capacitor Bank Controller - Series B - Manual (Page 24)

Publication 1413-UM001C-EN-P - May 2006
22 Installation
To change from the default Ethernet addresses, additional software is
required.
The ENI Utility is a free download used to configure the Ethernet
interface module.
The ENI Utility can be found at:
http://www.ab.com/micrologix. Follow the links to Get Software and
EtherNet/IP and DeviceNet Interface Configuration Utilities.
For information on using the ENI utility, please refer to Rockwell
Automation Knowledgebase article A19540 - Quick Start -- Getting
started with using the ENI Utility.
You need to supply 24V dc power to the Ethernet Interface while
using the ENI utility since the cable to the MicroLogix 1500 controller
is disconnected. After reconfiguring the Ethernet address, cycle power
to the Ethernet interface module.
Changing from the default addresses in the Powermonitor meters must
be done using the Powermonitor display module.
Refer to Powermonitor Meter Configuration on page 23.
Changing the PanelView 550 communications settings requires the use
of PanelBuilder32 software, which is purchased from your local
Allen-Bradley representative or distributor.
Additional Powermonitor Meters Option
The capacitor bank controller base system and HMI options provide
for the addition of up to three more Powermonitor meters. The
MicroLogix 1500 controller logic is designed to communicate with
Powermonitor meters that have the following communications
settings. If Ethernet Powermonitor meters are added to the system,
their Ethernet addressing should be configured per your networking
requirements.
PanelView 550 Ethernet Configuration Settings
Device / Parameter MicroLogix 1500 Controller
via NET-ENI PanelView 550 Operator
Terminal Powermonitor Meter 1
IP Address 192.168.0.100 192.168.0.105 192.168.0.101
Subnet Mask 255.255.255.0 255.255.255.0 255.255.255.0
Default Gateway 192.168.0.1 192.168.0.1 192.168.0.1