Schroth Racing All models - Competition Instructions - Manual (Page 52)

2. How to operate tilt lock adjusters
SCHROTH racing harnesses utilise “tilt lock adjusters” for quick adjusting
the harness belt.
To lengthen a strap, tilt (lift) the
adjuster up to 90 degree relative
to the strap and pull in direction
as indicated.
To tighten a strap, pull at the
protruding strap end as
indicated.
If tilt lock adjusters are equipped with a release strap, simply loosen the
harness belt by pulling on the strap to lift the adjuster.
Make sure the adjusters are correctly positioned to avoid interference
with the seat or the wearer’s neck during normal use as well as during
an accident. See section of this manual titled “Initial Restraint
Installation”.
Made to measure racing harnesses often do not have adjusters at
lap belts and/or anti-sub straps. If such a harness is used, make sure
body tight length is achieved during initial installation. If necessary
re-adjust the strap lengths at brackets.
Follow instructions in section “Wrap Installations”.
- 51 -