Schroth Racing All models - Competition Instructions - Manual (Page 25)

W RAP S YSTEMS TO ROLL BAR INSTALLATION AND BRACKETS ASSEMBLY
3-
BAR SLIDE WRAP
This installation is commonly used for
• shoulder strap roll cage installation
and
• to assemble open strap ends to brackets.
Do not install a lap belt directly to a roll cage by wrap around
technique.
W HAT DO YOU NEED :
ƒ open strap ends
ƒ a 3–bar slide for either 50mm (2“) or 75mm (3“) wide webbing
and
ƒ
an accessible roll cage bar
or
ƒ
an homologated bracket made by SCHROTH.
Racing harness with end brackets assembled to the shoulder belts by a
3-bar slide allow to dismount the brackets and use the 3-bar slide for
wrap around installation directly to the roll cage. Also brackets can be
exchanged e.g. from a snap-on to a bolt-in bracket or vice versa.
Sfi 16.5/NASCAR Regulations:
Brackets with at least 50 mm (2”) wide slots are required for use with
75 mm (3”) wide webbing. Snap-on brackets are not allowed.
- 24 -