Schroth Racing All models - Competition Instructions - Manual (Page 38)

Never try to drill a larger bolt hole into any bracket. The bracket
may be weakened or stick to your drill bit and the bracket and
attached webbing and its hardware may spin and may cause
severely injuries or death.
Needed equipment:
• hammer
• bench vice
• gripper/pliers
Bending Procedure
• Determine direction the bracket should face when being installed.
• Use bench vice, gripper and hammer to bend and wind the bracket
as needed.
• Make sure the bend allows enough space for the bolt head and
wrench.
• Bracket can be wound and bent up to 90° in either direction.
Do not bend bracket back and forth several times. Multiple
bends in opposite directions will weaken the material and the
bracket may fail during an accident.
Make sure the webbing is not damaged during bracket bending
or the webbing may fail during an accident.
Severe injury or death may occur.
- 37 -