SATEC PM175 Manual - Manual (Page 55)

‎Chapter 3 Display Operations Menu Operations
Series PM175 Powermeters 55
1. Select “CtrL” in the upper window using the UP and
DOWN arrow buttons.
2. Press the SELECT button to activate the middle window.
Use the UP and DOWN arrow buttons to select the desired option.
“On” enables password protection, “OFF’ disables password
protection.
3. Press ENTER to confirm your new setting, or ESC to
discard changes.
To exit the menu, press ESC.

When password protection is enabled, you are not allowed to
change the device settings through the display or communications
unless you provide a correct password. If you cannot provide a proper
password, contact your local distributor for the appropriate password
to override password protection.

Entering a wrong password three times in succession for five
minutes is treated as a tampering attempt and is recorded to the
device event log.
Setting the Device Clock
To enter the menu, select the “rtc” entry from the main menu
and press the ENTER button. This menu allows you to set up
the device clock and to configure your local time zone settings.
To select a setup option, use the UP and DOWN arrow
buttons from the upper window.
To change the time, date, or daylight savings setting:
1. Highlight an item you want to change by pressing briefly
the SELECT button. When you enter the time setup
display, the hours and minutes are frozen to allow you to
adjust them.
2. Adjust the selected item with the UP and DOWN arrow
buttons.
3. Highlight the next item you want to change and adjust it in
the same manner.
4. Press ENTER to confirm your changes, or press ESC to
leave the clock settings unchanged. If you confirm the
time change while the seconds are highlighted, the
seconds are zeroed; otherwise they stay unchanged.
To exit the menu, press ESC.
The following table lists available options.
Label Option Format/Range Description
hour Time hh.mm.ss The time is displayed as hh.mm.ss, where
the hours and minutes are shown in the
middle window separated by a dot, and
the seconds - in the lower window.
dAte Date YY.MM.DD,
MM.DD.YY,
DD.MM.YY The date is displayed as per the user
definition, where the first two items are
shown in the middle window, and the last
one - in the lower window. For
instructions on how to select the date
format, see “Display Setup”.
CtrL
On
hour
25.
17.43.
dAtE
05.
01.23.