SATEC PM175 Manual - Manual (Page 47)

‎Chapter 3 Display Operations Menu Operations
Series PM175 Powermeters 47
Label Parameter Options Default Description
Addr Device address Modbus: 1-247
DNP3: 0–65532
1 Device network address
bAud Baud rate 300-115200 bps 19200 bps The port baud rate
dAtA Data format and
parity 7E, 8N, 8E 8N 7E data format should
not be used with the
Modbus RTU and DNP3
protocols
Network Address
This menu allows you to configure the device IP address and
the default gateway address for the Ethernet port. To enter the
menu, select “nEt” from the main menu, and then press the
ENTER button.
To change the IP Address and Default Gateway:
1. To change the device IP address, select the “A” entry in
the upper window with the UP and DOWN arrow buttons.
To change the default gateway address, select the “G”
entry.
2. Press the SELECT button to activate the first address
digit.
3. Use the UP and DOWN arrow buttons to adjust the digit.
4. Press the SELECT button to advance to the next digit.
5. Adjust the remaining address digits.
6. Press ENTER to confirm your new setting, or press ESC
to discard changes.
To exit the menu, press ESC.
Counters Setup
The PM175 has four six-digit counters that can count pulses
delivered through the device digital inputs with a
programmable scale factor, or events that trigger setpoint
operations. This menu allows you to link digital inputs to the
counters and define a pulse multiplier for each counter. To
enter the menu, select the “Cnt” entry from the main menu and
press the ENTER button.
The menu uses three entries:
1. The upper window indicates a counter number.
2. The middle window selects a digital input to be linked to
the counter.
3. The lower window defines a counter multiplier.
Use the UP and DOWN arrow buttons to scroll to the desired
counter.
To change the counter options:
1. Press the SELECT button to activate the middle window.
2. Use the UP and DOWN arrow buttons to link a digital
input to the counter or to disable the counter input.
3. Press the SELECT button to activate the lower window.
4. Use the UP and DOWN arrow buttons to enter the desired
multiplier.
5. Press ENTER to confirm your changes and to store the
new settings, or press ESC to discard changes.
Cnt.1
1
Inp.1
A. 192.
000.203
168.
G. 192.
000.001
168.