SATEC PM175 Manual - Manual (Page 113)

‎Chapter 4 PAS Application Software Remote Device Control
Series PM175 Powermeters 113
4. Check the “Ev On” box for the points you wish to be
included into event poll reports.
5. In the “Ev Class” box, select the event poll class for the
change event points.
6. Repeat these steps for all points you want to be monitored
for events.
Click Send to download your setup to the meter.
Remote Device Control
This section describes online operations on the meter you can
perform through PAS. To access device control options you
should have your device online.
Remote Relay Control
PAS allows you to send a command to any relay in your
device or release a latched relay, except of the relays that are
linked to an internal pulse source. These relays cannot be
operated outside of the device.
To enter the Remote Relay Control dialog, check the On-line
button on the PAS toolbar, select Device Control from the
Monitor menu, and then click on the Remote Relay Control
tab.
To send a remote command to the relay:
1. From the “Relay Command” box for the relay, select the
desired command:
OPERATE – to operate a relay
RELEASE - to remove your remote command, or to
release a latched relay
2. Click on Send.