MacDon PW8 Pick-Up Header - Manual (Page 93)

MAINTENANCE AND SERVICING
Table 4.9 O-Ring Face Seal (ORFS) Hydraulic Fittings
Torque Value 4
SAE Dash
Size
Thread
Size (in.)
ft·lbf
(*in·lbf) N·m
-3 Note 5 – –
-4 9/16–18 18–21 25–28
-5 Note 5 – –
-6 11/16-16 29–32 40–44
-8 13/16-16 41–45 55–61
-10 1–14 59–65 80–88
-12 1-3/16-12 85–94 115–127
-14 Note 5
– –
-16 1-7/16-12 111–122 150–165
-20 1-11/16-12 151–167 205–226
-24 2–12 232–256 315–347
-32 2-1/2-12 376–414 510–561
4.2.2 Recommended Fluids and Lubricants
Lubricant Specification Description Use
High Temperature Extreme
Pressure (EP2) Performance With
1% Max Molybdenum Disulphide
(NLGI Grade 2) Lithium Base
As Required Unless
Otherwise Specified.
Grease SAE Multi-Purpose
Extreme Pressure (EP) Performance
With 1.5–5% Molybdenum Disulphide
(NLGI Grade 2) Lithium Base
Drive Motor Shaft
• Your machine can operate at top efficiency only if clean lubricants are used.
• Use clean containers to handle all lubricants.
• Store in an area protected from dust, moisture, and other contaminants.
4. Torque values and angles shown are based on lubricated connection, as in reassembly.
5. O-ring face seal type end not defined for this tube size
169489
85
Revision A