MacDon PW8 Pick-Up Header - Manual (Page 66)

OPERATION
3. Loosen the two bolts (A) on auger stops on both ends
of header.
4. Loosen jam nuts (B) on adjuster bolts (C).
5. Turn adjuster bolt (C) to lower or raise the auger.
6. Manually rotate the auger to check for interference, and
to check clearances between the auger flighting and
auger pan, and adjust as necessary.
7. Tighten jam nuts (B), and downstop nuts (A).
8. Check clearances between auger flighting and stripper
plates, and adjust as required. Refer to Section:
Stripper Plate Clearance, page 61 .
Figure 3.64: Left End
Figure 3.65: Right End
Auger Float
The auger has an upward float range of 1-5/16 in. (34 mm), but can be locked so that it does not float, which may
be desirable in certain crop conditions.
169489
58
Revision A